ADVANTEST

ADVANTEST

Japan

ABOUT ADVANTESTINVESTORSPRODUCTS & SUPPORTNEWSENVIRONMENTCAREERS
HOME


Press Release FY2011


Press Release FY2010


Press Release FY2009


Press Release FY2008


Press Release FY2007

Advantest Launches T5385 Memory Test System
July 28, 2009
New DRAM Wafer Test System Offers Industry-Best 768-DUT Parallel Test Capacity

T5385
TOKYO, Japan, July 28, 2009 - Advantest Corporation (TSE: 6857, NYSE: ATE) today announced availability of its new T5385 memory test system for DRAM wafer test, offering a parallel test capability of 768 devices - the highest in the industry, and twice the capability of the company's previous model. The T5385 will be available from August.

Demands at wafer level test continue to increase for both improved performance and a lowered cost-of-test. Advantest's new T5385 addresses these issues and improves efficiency per device while scaling even higher in parallelism. Furthermore, with 533Mbps capability, the T5385 delivers Known Good Die (KGD) for consumer devices, to greatly improve yields for tomorrow's LPDDR2 (Low Power DDR2) and DDR3 multi-die and stacked devices.

New Tester Improves Throughput in Wafer Test Process
DRAM memory chips used in today's computers and other electronics deliver faster processing speeds, higher data storage volumes, and more efficient power consumption than previous generation devices, at progressively lower prices. To enable these gains, the semiconductor industry is aggressively migrating to smaller process nodes that allow more chips and greater densities to be produced from each wafer. Throughput has therefore become a critical issue in DRAM wafer test, with chipmakers demanding significant gains to increase productivity. Advantest's new T5385 delivers an unrivalled parallel test capability and flexible pin configurations that significantly improve throughput in the wafer test process.

Features and Benefits
(1) Industry's highest DRAM wafer test parallel capability of 768 devices
The T5385 boasts a parallel test capability of 768 devices - twice the capability of Advantest's previous model, the T5383, and the highest in the industry. Massively parallel testing reduces touchdowns and helps to lower test costs significantly in high-volume wafer fabs. The new tester is also equipped with a flexible pin configuration that supports diverse DRAM devices, allowing tester pin resources to be optimally allocated for greater efficiency.
(2) High-Speed MRA
Enabled by hardware and software advances, the T5385 offers a high-speed MRA (Memory Repair Analyzer) for DRAM and flash memory wafer test that reduces test time by 30%, compared to the previous model.
(3) Reinforced Flash Memory Test Capability
The T5385 also supports flash memory wafer test. It boasts a proprietary tester-per-site architecture optimized for flash memory, contributing to reduced test times.
(4) T5385ES Memory Test System for DRAM R&D Also Available
Designed for engineering use, the smaller T5385ES offers all the functional and performance qualities of the T5385. Engineers can easily perform evaluation and characterization, and test programs developed on the T5385ES can be seamlessly transferred to the T5385, accelerating DRAM development processes.

With the announcement of the T5385ES and T5385 test systems, covering DRAM and flash memory wafer test from development to high-volume production, Advantest again affirms its commitment to providing best-in-class test solutions.

Key Specifications
Target Test Devices : DDR3 / DDR2-SDRAM,
NAND / NOR Flash memory, etc.
Parallel Test Capacity :
T5385 : 768 (x4 I/O channels)
T5385ES : 12 (x4 I/O channels)
Maximum Test Speed : 266MHz / 533Mbps

Further Enquiries
Enquiries about this product should be directed to:
Strategic Sales Division +81-3-3214-7505
Note: All information supplied in this release is correct at the time of publication, but may be subject to change without warning.

About Advantest
Advantest Corporation is the world's leading automatic test equipment supplier to the semiconductor industry, and also produces electronic instruments and systems. A global company, Advantest has long offered total ATE solutions, and serves the industry in every component of semiconductor test: tester, handler, mechanical and electrical interfaces, and software. Its logic, memory, mixed-signal and RF testers and device handlers are integrated into the most advanced semiconductor production lines in the world. Founded in Tokyo in 1954, Advantest established its first subsidiary in 1982, in the USA, and now has subsidiaries worldwide. Among them, Advantest America, Inc. is based in Santa Clara, CA., Advantest Europe GmbH is based in Munich, Germany, and Advantest Taiwan Inc. is based in Hsinchu, Taiwan. More information is available at www.advantest.co.jp.
Index of Press Release 2009
Legal | Privacy Policy | Sitemap | Contact | © Copyright 2012 ADVANTEST CORPORATION